Megger EVCA210 Electric Vehicle Charge-Point Adaptor UK

Accessory for the MFT-X1, MFT1700 and MFT1800 series to enable electrical vehicle charge point testing

Type 2 Charging Plug for charging points with panel mounted socket outlet or fixed cable with vehicle connector

The Megger EVCA210 is a compact, simple to use adapter designed to perform all the functions required by the electrical contractor to fully test Mode 3 AC Electric Vehicle Charge-points. Specially designed to comply with UK, European and other international wiring regulations and standards, the EVCA210 may be used on all single and three phase electric vehicle charge points with appropriate connectors. They are designed to test the function and safety of a charging point. The adapters allow you to conduct tests using appropriate single or multifunction test instruments on EV charging points in accordance with IEC/EN 61851-1 and IEC/HD 60364-7-722. Charging points should be tested as part of the initial installation and repeated periodically.

Features:

• Push Button for PE Pre-Test „Push button for CP Error “E” simulation
• Push button for PE Error (Earth Fault) simulation
• Rotary switch providing PP State simulation
• Rotary Switch providing CP State simulation
• Type 2 Charging Plug for charging points with panel mounted socket outlet or fixed cable with vehicle connector
• Type 1 Charging Plug for charging points with fixed cable and vehicle connector
• IP54 Rating
• Carrying Case
• CAT II 300V Rating
• Comply with Low Voltage Directive LVD 2014/35

What’s Included? :

• Megger EVCA210-UK Electric Vehicle Charge-Point Adapter
• Type 1 Charging Plug
• Type 2 Charging Plug
• Soft Carry Case
• Instruction Manual

Data Sheet:

Click Here for Data Sheet