Set of 4 Saenz Steel Slipper Rods for Vauxhall 2.0L XE. Each Rod has a 18 mm Pin Size, 149 mm in Length with a Standard 26.35 mm Width Big End and ARP L19 Bolts.

This con-rod will suit the standard XE crank dimensions (26.35mm big end). The overall rod length has been increased to 149mm due to the new smaller pin size of 18mm and the pin is moved to the crown due to its smaller diameter. The overall deck height is reduced to allow the standard block face to be machined to ensure perfect accuracy across the top of the block. The rod also incorporates the latest designs for improved strength yet is still lighter than the original design.

This design of rod has several improvements which benefit the engine. There are two vertical grooves on the side of the rod, this directs the oil spray as it exits the big end vertically upwards towards the pin and the crown of the piston. This has two benefits, it helps to supply lubricant directly to the gudgeon pin also the cool jet of oil to the underside of the crown of the piston helps to reduce the temperature of the piston itself. On the small end, the oil hole has been repositioned which feeds the small end bush. This is because the one at the top which is normally used effectively weakens the rod itself which increases the possibility of breakage when the rod is brought down by the crankshaft. By moving the oil hole to the side of the rod, there is far more material in this area to help maintain its strength.

Because of the above modifications it is no longer necessary to supply an oil feed through the bearing, even if your bearing still has a hole for the oil jet, it does not reduce its improvement, the hole is simply filled with oil and the pressure in this area is maintained.

These Slipper Rods are suitable for use with:

• 87mm Vauxhall 2.0 Slipper Pistons (18mm Pin)
• 88mm Vauxhall 2.0 Slipper Pistons (18mm Pin)